
Charcoal Standing Seam Metal Roof in Austin, TX
Shingles traded for charcoal standing seam metal, with hidden fasteners and a custom chimney cricket.
Residential - Standing Seam Metal - Austin, TX
The Last Roof This Austin Home Will Need
This Austin homeowner wanted to stop the cycle of shingle replacements for good. We replaced it with a charcoal standing seam metal roof, with panels that run unbroken from eave to ridge, hidden fasteners, and a custom metal cricket behind the chimney to keep water moving.

Project at a Glance
Location
Austin, TX (Travis County)
Home
Single-story home with a stone chimney
Previous Roof
Asphalt shingles
New Roof
Charcoal gray standing seam metal
Key Detail
Custom metal chimney cricket
Warranty
25-year workmanship warranty
Ending the Cycle of Shingle Replacements
This single-story home has a long main roof, a front gable over the entry, and a stone chimney sitting right in the middle of the roof plane. Every rain, water runs down the slope and straight into the back of that chimney, which is exactly where roofs like this tend to leak.
The homeowner had been through shingle roofs before and didn’t want to do it again. Standing seam metal was the answer: a roof built to last decades, with nothing to blow off in a storm.

What Is a Chimney Cricket, and Why It Matters
A chimney in the middle of a roof acts like a dam. Water and debris pile up behind it, and over time that’s where flashing fails and leaks start.
Behind this chimney, we built a metal cricket: a small, peaked diverter that splits the water and sends it around both sides of the chimney. Then we flashed the stone into the new roof and sealed every vent and pipe, finished to match the charcoal panels. See more of our custom sheet metal and flashing work.
The Work
Panels That Run Eave to Ridge
We installed charcoal gray standing seam panels across the entire home. Each panel runs in one piece from the eave to the ridge, with no horizontal seams for water to find.
Hidden Fasteners
The fasteners sit under the raised seams, out of the sun and the weather. There are no exposed screws to back out and no rubber washers to dry-rot, two of the most common failure points on cheaper metal roofs.
Every Penetration Finished to Match
Vents and pipes were flashed, sealed, and finished to match the roof, so the details look as clean as the panels and stay watertight for the long run.
Considering metal? Learn more about standing seam metal roofs and our other metal roofing options.
What This Project Shows
01
Metal Ends the Replacement Cycle
A standing seam roof can outlast several shingle roofs.
02
Chimneys Need a Plan
A cricket and proper flashing stop the most common leak on a roof like this.
03
Hidden Fasteners Last Longer
Concealed fasteners avoid the screws and washers that fail on exposed-fastener metal.
04
Charcoal Looks Sharp
A dark standing seam roof gives a traditional home a clean, modern edge.
What Customers Say After the Work Is Done
Charcoal Standing Seam Metal Roof in Austin: Common Questions
What is a chimney cricket?
A cricket is a small, peaked structure built on the uphill side of a chimney. It splits the water running down the roof and sends it around the chimney instead of letting it pool against the back. Building codes generally require one on chimneys wider than 30 inches, and it’s smart on smaller ones too.
How does standing seam handle Central Texas hail?
Better than most roofs. Many standing seam panels carry a UL 2218 Class 4 impact rating, the highest available. Very large hail can still leave cosmetic dents, but a metal roof is far less likely to crack or leak after a storm than a shingle roof.
Can a metal roof lower my insurance premium?
It can. Many Texas insurers offer discounts for Class 4 impact-resistant roofs. Ask your agent what your policy offers before you choose a roof.
How much does a standing seam metal roof cost in Austin?
It depends on the size and pitch of the roof, the panel and finish, and details like chimneys, skylights, and valleys. Standing seam costs more upfront than shingles, but it can last decades longer. Our standing seam metal roofing page covers what drives the price, and estimates are free.
Can you replace a shingle roof with standing seam?
Yes. That’s exactly what this homeowner did. We remove the old roof, check the decking, install new underlayment, and then install the metal panels, trim, and flashing.
Do you install metal roofs throughout Austin?
Yes. We install metal roofs across Austin and nearby communities, including Lakeway, Bee Cave, Pflugerville, Round Rock, Cedar Park, Dripping Springs, and Buda.
Related Projects
Ready to Make This Your Last Roof?
We’ll assess your home, walk you through panel and color options, and give you a clear written estimate, with no pressure.
Free inspections and estimates
Ready to Make This Your Last Roof?
Tell us how to reach you, and our team will follow up about your roof. Free inspections and estimates. No obligation.
Water coming in now? Call 512-271-6893San Antonio: 210-512-4132
Want to share more details or choose an inspection time? Book an inspection online.
"*" indicates required fields




